56
Mounting the Tube / Cable Casing
Assemblies
The STL-80SS includes two tube / cable casing
assemblies. The magnetic metal casing
assembly is designed to cover and hold the 9-
Tube Assembly level with the Injector
Assembly. It also channels the tubes, the Drive
Motor cable, and the Touch Panel ethernet
cable back to the rear of the freezer. The
smaller, black plastic casing is for channeling
the Touch Panel ethernet cable and draw
switch cable down the side of the freezer, to the
metal casing.
The following instructions and illustrations show
a left-side mounting, but right-side mounting is
possible when the Injector Assembly is installed
on the right.
1. Prepare detergent water by mixing several
drops of Dawn
®
dish soap with a gallon of
warm water (108°F / 42°C).
2. Determine where the metal casing
assembly will be placed. The curved ends
of the casing typically hang over the front
and back of the freezer, and is level
horizontally with the 9-Tube Assembly, the
syrup line manifold, and the Injector Head
syrup port. This puts the least amount of
strain on where the manifold connects with
the Injector Head.
In some cases, the Drive Motor extends
past the side of the freezer and will not
allow for the front end of the casing to be
placed forward. In these instances, the
casing will need to be installed further back,
and above the level of the 9-tube assembly,
to allow the tubes to curve slightly
downward and around the Motor.
Above all, ensure the syrup line manifold is
level horizontally with the Injector Head
syrup port and the tubes are not putting
strain on the connection upward or
downward.
3. The Casing Assembly contains very power
magnets to attach to the side of the freezer.
Simply place the assembly in line with the
Injector Assembly with the hinged surface
downward (screws at the top). The casing
assembly should be level horizontally.
4. Remove the screw from the top of the
casing assembly.
5. Swing the casing cover open.
6. Place the 9-Tube Assembly tubes inside the
casing. Also place the Drive Motor cable
inside this casing. Pull any excess tubes
and cables to the back of the freezer,
allowing enough slack in the front to
comfortably curve around to the Injector
Assembly, but not enough to droop or hang.
Содержание STL-80SS
