Volkswagen VAS 6321 A, Инструкция по использованию

Страница: 27 / 68

Wo r k i n g w i t h t h e C B R B i t s
27
9.5 The CBR pull rods
Select the appropriate pull rod for the number of bits welded on, and insert this through the slotted holes of the bits.
If the damage to the body part is slightly deeper than the height of the slotted holes, it is possible to reach the deeper parts of the
damage by tilting the outer bits.
Ø 7 mm Ø 8 mm
9.6 When to use which pull rods / pull rod diameter
The pull rods are available in two diameters (Ø 7 mm and Ø 8 mm) and in four different lengths. For rigid deformations such
as sills, elbows, etc., choose the thicker 8 mm diameter pull rods.
The 7 mm diameter pull rods (and in this case especially the long pull rods) have the advantage that they bend easily at higher
pulling forces and thus allow desired overstretching, e.g. for soft deformations in surfaces such as on side panels and doors.
Select the length of the pull rods according to the pattern of damage.
For sharp contours 8 mm diameter pull rods are recommended. For gentle contours and curvatures, use of 7 mm diameter
pull rods is recommended.