4
Aileron servo cavity
4B- Aileron servo location
4A- The servo componemts
STAGE 4
- INSTALLING THE AILERON SERVO INTO THE WING.
To install the aileron servo into the wing you will need the fol-
lowing items :
- 2 servos
- Servos mounting screws and grommets as supplied with ser-
vos.
- Servo control arms as supplied with the servos.
- Two aileron control rod assemblies supplied with the kit. The
assemblies consist of a metal rod with clevis screwed onto both
ends.
- Low tack masking tape.
- 2 aileron control horn assemblies
- 1 servo wire connection wire
STAGE 5
- INSTALLING AILERON CONTROL SYSTEM
5A- Aileron control rod assembly 5B- Aileron control horn assembly
5C- Aileron control installed
5.1
Consult your radio instruction manual and center the aileron servo by plugging it into the aileron channel in the
receiver. Turn on the transmitter and then the receiver. Center the aileron trim lever on the transmitter. Remove the
servo arm mounting screw and the servo arm.
5.2
Mount the servo arm back on the servo so that the arm is parallel with the back edge of the wing. Screw the
arm into place with the servo arm mounting screw supplied with the servo.
5.3
Locate the two aileron control rods in the hardware bag (see 5A). Ensure the clevises are screwed well onto
the threaded portion of the rod. Rotate and tug aggressively on the clevises and ensure that they are not loose on
the rods.
5.5
Ensure that the aileron control horns are screwed onto the threaded aileron control horn bolts and that both
control horns are in approximately the same place on their respective bolts.
Aileron
Aileron
Aileron
4.1
Carefully remove the white cover plates from the aileron
servo cavities. Ensure you know which cover plate is for the
right wing and which is for the left. Notice that there are wood-
en servo rails pre-installed into each servo cavity end.
4.2
Locate the wiring harness tubes that are protruding slightly
into each aileron servo cavity. The tube can be moved slightly
at this point. Check out the other end of each tube for a clean
position and then using C/A glue secure the wiring harness
tubes at the aileron servo cavity end.
4.3
Install a servo in each aileron servo cavity and connect the
servo wire to the servo extension wires and run the extension
wires through wiring harness tubes to the centre of the wing
Install the aileron control horns
4C- Aileron servos mount
4D- Screw servo in position
4E- Install aileron control horn
Aileron
