12
23.1
Connect the elevator servo to the receiver and turn on your transmitter. Confirm that
the neutral positions of the elevator servo are sustained as per illustration 22C
22B- Pre-installed elevator, throttle and rudder
pushrod
22C- Center the servos, control surfaces & throttle
(carb) then connect the control rods to the servos.
23A- elevator control horns
shown in position
23B- Loosen the set screws to connect the elevator pushrods to the ele-
vator control horns, align the elevator surfaces so that it is level with the
plane of the horizontal stabilizer, then tighten set screws securely.
24.1
Connect the rudder servo to the
receiver & turn on your transmitter.
Confirm that the neutral position of
rudder servo is sustained as per illus-
tration 22C
24A - The rudder pushrod is connected to the rudder control horn
25.1
With the throttle control arm clevis connected to the engine throttle
arm, move the throttle arm to roughly half throttle. Look into the throat of
the engine carburetor as you rotate the throttle arm and select a position
where the throttle opening is about haft what it is when fully open.
25A- Throttle control rod connected to the engine throttle arm and
to the servo arm
Connected to the engine throttle arm
engine throttle arm
25B- Throttle control rod con-
nected to the engine throttle arm
Elevator pushrod
Throttle pushrod
Rudder pushrod
STAGE 23
- CONNECTING THE PUSHRODS TO THE ELEVATOR
STAGE 24
- CONNECTING THE PUSHRODS TO THE RUDDER
STAGE 25
- CONNECTING THE THROTTLE CONTROL
NOSE
TAIL
NOSE
TAIL
