VM TEK Biomasse PIKO, Инструкция по эксплуатации

Страница: 29 / 48

29
Keys and LEDs on 4Heat modules
Installation
To test the device, perform the following procedures:
1. Connect the 4HEATModule to the power supply:
• WiKEY: make sure that the equipment (boiler, stove or stove) is connected to the
network;
• PinKEY: Wi-Fi led (a) fixed red;
2. Connect the 4HEAT Module to the electronic board using the cable provided in the
kit:
• WiKEY: already connected to the heating system (boiler, stove or stove);
• PinKEY: the Wi-Fi Led Steady Red, if at the end of the configuration procedure the Wi-Fi
Led (a) turns Steady Green the device does not communicate correctly with the board,
make sure that the device is connected correctly and that the heating system (boiler,
stove or stove) is connected to the electrical network;
3. Wi-Fi communication: if the Blue LED has a steady light, the communication with the
application was successful and the device is communicating correctly, while in WiKEY we will
have the fixed Wi-Fi led;
4. Hardware reset key: Press in case of persistent product malfunction. The WiKEY device
does not have a reset key.
If the appliance is off during normal operation, press button (b) for 4 seconds.
During setup and operation, the LEDs may change from steady light to flashing.