VM TEK Biomasse PIKO, Инструкция по эксплуатации

Страница: 16 / 48

16
User Menu 1
Views By successively clicking on the P1 button, the display shows:
tP: DHW temperature [°C]
tF: Smoke temperature [°C]
UF: Smoke extractor speed / Voltage [RPM / Volt]
Co: Speed / Feeder ON time [RPM / sec ]
PA: Water Pressure [ mbar ]
FL: Primary airflow velocity
St: Time remaining for maintenance 1 [h]
FUNC: Winter/Summer
FC: Firmware Code and Revision
Combustion Power
Configuration Click the P3 button: the D2 display flashes. With another click of
the same button, the power is changed. Eg: 1
– 2 – 3 – 4 – 5 – A (A
= automatic combustion). After 5 seconds, the new value is
saved and the display is shown as normal.
Manual pellet
loading A long press on the P3 button activates the manual loading of
pellets with continuous activation of the worm gearmotor. The
bottom display shows the word LoAd, the top display shows the
elapsed loading time. To stop charging, press any button.
Charging stops automatically after 300 seconds. Enabled only if
A48 = 0.
Pellet loading
correction A long press of the P2 button activates this function (You have to
do this twice to enter the modification mode). The bottom
display shows PELL, the top shows the value. With the P2 / P4
buttons the value is increased or decreased;
the factory value
is "0". After 5 seconds, the new value is saved and the display
is shown as normal.
Enabled only if A64 = 1.
Combustion fan
correction
– smoke
extractor
Long press of the P4 button activates this function (you need to
do this twice to enter modification mode). The lower display
shows Vent, the upper one shows the value. With the P2 / P4
buttons the value is increased or decreased;
the factory value
is "0 ". After 5 seconds, the new value is saved and the display
appears as normal.
Enabled only if A64 = 1.
Thermostat setup The current thermostat value is shown on the lower display; if
P69 is different from 0 and the airflow is controlled by remote
control, thermostat Th53 will be displayed.