VITO PRO-POWER VISCC12210, Инструкция по эксплуатации

Страница: 19 / 32

EN
19
THE OPEN CUTTING MODE
OPERATING INSTRUCTIONS
MULTI-TABLE SAW
CONFIGURATION
WARNING: It is important that the
operator is adequately trained in
the use, adjustment and operation
of the power tool, and has read
the “Instruction Manual” before
commencing operations.
NOTE: We recommend that when
the machine is being used as a
“Miter Saw”, the complete “Table
Saw Rip Fence Assembly” is
removed from the machine and
stored safely for future use.
HOW TO RELEASING THE
CUTTING HEAD
NOTE: When configuared in MITER
SAW MODE the “Cutting Head”
will be automatically locked in its
upper position with the “Retractable
Lower Blade Guard” completely
covering the balde teeth.
To release the “Cutting Head”. Hold
the “Cutting Handle” and press
the “Cutting Head Release Lever”
down slowly. The operation of the
“Retractable Lower Blade Guard is
automatic opening.
NOTE: We recommend that when
the machine is not in use the
“Cutting Head” is locked in its down
position, with the “Auxiliary Lower
Blade Guard” correctly installed
and the “Cutting Head Latching Pin”
fully engaged in its socket.
Raise the bable top to its upmost
position and tighten the height
adjustment screw.
The first step:
Pull out the cutting head latching
pin and allow the cutting head to
rise to its upmost position. Refer the
diagram 9.
The second step:
1. Remove the “Auxiliary Lower
Blade Guard” and store safely for
future use.
2. Press the “cutting head release
lever” button down, hold the
“cutting handle”and forced upward
it at the same time.
PREPARING TO MAKE A
CUT
1. Avoid awkward operations and
hand positions where a sudden slip
could cause fingers or hands to
move into the balde.
2. Cut only one workpiece at a time.
3. Clear everything except the
workpiece and related support
devices away from the blade fefore
commencing operations.
4. Fasten the workpiece using
clamp to hold the workpiece
securely to the table and fence.
HANDS AND BODY
POSITION
- Never place hands within the “NO
HANDS ZONE” (at least 140mm
away from each side of the blade).
Pictograms on the machines rotary
table are provided as an aid to safe
working practices. Keep hands away
from the path of the blade.
- Hold the workpiece firmly to the
fence to prevent any movement. Use
a “Hold Down Clamp” if possible
but check that it is positioned that it
does not interfere with the path of
the blade or other moving machine
parts.
The third step:
Press the switch ON position. The
power tool is working now. Slightly
push down on the “Cutting Heads
Handle” at the same time.
Before attempting a cut, press
down the “Green switch button”
ON position and press the “Cutting
Head Release Lever” down, at
the next step please pressure the
“Cutting handle” slowly, so that you
can see the blade. Opposite, when
you want to stop the cutting ,the
cutting that please stop to pressure
the “Cutting handle” with your hand.
cutting head
latching pin
press the “cutting
head release lever”
button
280mm
NO HANDS ZONE NO HANDS ZONE
cutting head
ON/OFF switch
Green button
Red button