VITO PRO-POWER VISCC12210, Инструкция по эксплуатации

Страница: 18 / 32

18
EN
work more humane and happiness
Reduce the work fault and promote
cutting precision .
EXTEND POLE
This assemblies was supplied with
the seller or manufacturer.
Left & right side of each distribution
two socket. Inster “Extend pole” into
the sockets at the left & right side.
LOWER BLADE GUARD
This assemblies was supplied with
the seller or manufacturer.
Remove the “lower blade guard”
and store safety for future use when
you use “open mode” of this power
tools. Opposite, when you finish
using the “open mode”, please clean
this machine and resetting the
“lower blade guard”.
CONFIGURE & USE THE
MULTI-PURPOSE TABLE
SAW
WARNING: Only carry out this
procedure with the machine
disconnected from the power
source.
CAUTION: The “TABLE SAW” has
many built in saferty interlocks.
It is important that the following
instructions, and those found on
the label attached to the machine
table are read, understood and
acted upon. Failure to carry out the
configuration procedure could result
in damage to the machine and/ or
injury to the operator.
TABLE CUTTING MODE
Note: The “Table cutting mode” is
optimally suited for the cutting of
thin wood material
such as laminate flooring etc.
Screw off the knobs on the right and
left sides with you hand. Raise the
bable top to its upmost position and
tighten the height adjustment screw.
Attention: The cutting thickness not
more than 30mm.
Connect the plug with a suitable
socket. Turn the switch on. Put
the wood on the table, the wood
along the arrow direction to move
forward. Use “Rip Fence” to adjust
the cutting length accurately.
RIP FENCE
Rip cutting is cutting along the
length of a piece of material rather
than across it. Rip cutting should
always be done with th “Rip fence”
set to the desired width and on the
right hand side of the machines
table.
Note: Check that the “Rip fence” is
locked in position and is parallel to
the saw blade.
Check that the riving knife is
properly aligned with the saw blade.
When ripping small section material
a “Push Stick” should be used to
feed/guide the final 300mm of the
material past the blade. A “Push
Stick” should always be used when
making cuts of less than 300mm.
NOTE: A “Push Stick” is provided
with the sell or manufacturer. We
recommend that when not in use
the “Push Stick” is stored on the
machine.
When ripping long boards or large
panels always use a remote work
support or enlist competent trained
help.
Feed the workpiece through the saw
keeping it indexed against the “Rip
Fence”.
Use smooth, steady pressure
and employ a “Push Stick” when
necessary.
Left extend
pole
Right extend
pole
lower blade guard
right adjusting knob
left adjusting knob
cutting thickness
30mm