Transcendent VT-TR5HA DVR Series
73
�
Enable or disable “Snap”, “Push”, “Alarm-out”, “Preset”, “Buzzer”, “Pop-up Video” and
“E-mail”. The alarm handling setting of line crossing alarm is similar to that of the sensor
alarm (see 9.1 Sensor Alarm for details).
�
Click “Apply” to save the settings. You can click “Crossing Config” to go to the line
crossing configuration interface.
9.3.4 Intrusion Detection
Intrusion Configuration
:
The relevant alarms will be triggered if someone or something intrudes into the warning areas
or moves in the warning areas drawn by the users.
�
Click Start
à
Settings
à
Camera
à
Intelligent Detection
à
Intrusion Detection to go to the
following interface.
�
Select the camera, enable the intrusion detection and set the duration.
�
Select the warning area. You can add 4 warning areas at most but only one can be used at
any time.
�
Draw the warning area of the intrusion detection. Refer to the interface as shown below.
Check “Draw Area” and then click around the area where you want to set as the warning area
in the image (the warning area should be a closed area). Uncheck the “Draw Warning Area” if
you finish the drawing. Click “Clear” button to delete the warning area.
�
Click “Apply” to save the settings.
�
Click “Processing Mode” to go to the alarm handling configuration interface of intrusion
detection.
Transcendent VT-TR5HA DVR Series
74
Intrusion Detection Alarm Handling Configuration
:
�
Click Start
à
Settings
à
Alarm
à
Intelligence Alarm
à
Intrusion Detection to go to the
following interface.
�
Enable or disable “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”, “Pop-up Video”
and “E-mail”. The alarm handling setting of intrusion detection alarm is similar to that of the
sensor alarm (see 9.1 Sensor Alarm for details).
�
Click “Apply” to save the settings. You can click “Invasion Config” to go to the intrusion
detection configuration interface.
