Vitek VT-8489, Инструкция по эксплуатации

Страница: 5 / 44

5
ENGLISH
•
Transport the unit in the original package only.
•
Keep the unit out of reach of children and dis­
abled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE
ONLY. ITS COMMERCIAL USAGE AND USAGE
IN PRODUCTION AREAS AND WORK SPACES IS
PROHIBITED.
BEFORE THE FIRST USE
After unit transportation or storage at low
temperature keep it for at least three hours
at room temperature before switching on.
BEFORE USING THE UNIT
•
Make sure that the unit is switched off.
•
Attention! Before using the coffee maker
for the first time remove the red rubber
plug from the water tank (16).
•
Before using the coffee maker for the first
time, wash all removable parts with warm
water and dry them.
• Before switching the unit on, make sure that
the mains voltage corresponds to the voltage
specified on the unit body.
• Remove the water tank (16), fill it with cold
water till the MAX mark and install it back to
its place.
• Remove the milk tank (11), fill it with cold
water till the MAX mark as well and install it
back to its place.
• Select one of the coffee filters (20 or 21), and
insert it into the holder (19), matching the
ledge on the filter with the hole on the holder
(19) and turn the filter clockwise/anticlock­
wise (pic. 1, 2).
• Install the filter holder into the coffee maker.
Position the handle so that it aligns with the
open lock symbol «
» on the unit and goes
into the groove (fig. 3), then turn the handle of
the filter holder (17) to the right until bumping
and until it aligns with the closed lock symbol
«
» (fig. 4, 5).
•
Place a corresponding cup on a respective
tray (3 or 5) (fig. 10) and turn the cappuccina­
tor pipe (2) to the cup using the bar (8).
•
Insert the power plug into the socket.
•
Switch the coffee maker on by pressing the
button (14), the illumination of the buttons
(23, 24 and 25) on the control panel will start
flashing.
•
When the illumination stops flashing, press
the cappuccino button «
» (24) twice.
•
Let the water run for 90 seconds.
•
The illumination of control buttons will light up
constantly, that means that the unit is ready
for operation and the boiler is clean.
Attention!
•
Do not remove the filter holder (19) during the
unit operation.
• Do not remove the filter holder (19) immedi-
ately after preparing coffee as there is redun-
dant water and steam pressure inside, let the
coffee maker cool down completely.
• To remove the filter holder (19) turn the han-
dle to the left and remove the holder.
Choosing the appropriate cup
Drink Estimated
volume of the
ready product
Espresso
One cup
Two cups
60 ml
119 ml
Cappuccino One cup
Two cups
178 ml
355 ml
Latte
One cup
Two cups
296 ml
474 ml
Note:
• The cups should be preliminary heated up, to
do this, put the cups on the tray (1) while water
heats up in the boiler.
CHOOSING THE RIGHT COFFEE
Whole-bean coffee
Coffee should be freshly ground and dark roast­
ed. You can try French or Italian espresso roasts.
Ground coffee only retains its aroma for 7­8 days,
provided it is stored in an airtight container and
in a cool, dark place. Do not store ground coffee
in a refrigerator or freezer. It is recommended to
grind whole beans just before consumption. Coffee
beans stored in an airtight container will retain their
aroma for up to 4 weeks.
Grinding
• If you grind and make coffee yourself, then
grinding coffee beans is a very important step
in the espresso process.
• The correct grinding for espresso should look
like salt.
•
If the grinding is too fine, the pressurized water
will not wet the coffee properly.
•
If the grinding is too coarse, the water will flow
too quickly, which prevents full aroma extraction.
• Be sure to use a quality coffee grinder to get an
even consistency.