Vitek VT-3613 BN, Инструкция по эксплуатации

Страница: 5 / 24

5
ENGLISH
• When unplugging the unit from the mains,
hold the power plug but not the cord.
• Do not connect or disconnect the power
cord from the mains and do not touch it
with wet hands, this may cause electric
shock.
• Do not allow children to touch the unit
body and the power cord during the unit
operation.
•
Do not allow children to use the unit as a
toy.
•
During the unit’s operation and breaks
between operation cycles, place the unit
out of reach of children.
•
The unit is not intended for usage by
physically or mentally disabled persons
(including children) or by persons lack-
ing experience or knowledge if they are
not under supervision of a person who is
responsible for their safety or if they are
not instructed by this person on the usage
of the unit!
• For children safety reasons do not leave
polyethylene bags used as a packaging
unattended.
• Attention! Do not allow children to play
with polyethylene bags or packaging film.
Danger of suffocation!
•
Check the power cord and plug periodi-
cally. Do not use the unit if its body, power
plug or power cord is damaged.
•
Do not use the unit if the power cord or
plug is damaged, if the unit malfunctions,
after the unit was dropped or damaged in
any other way.
•
Do not attempt to repair the unit.
Do not disassemble the unit by yourself,
if any malfunction is detected or after
it was dropped, unplug the unit and
apply to any authorized service center
at the contact addresses given in the
warranty certificate and on the website
www.vitek.ru.
• To avoid damages, transport the unit in
the original package only.
• Keep the unit in a dry cool place out of
reach of children and disabled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD
USE ONLY, ITS COMMERCIAL USAGE AND
USAGE IN PRODUCTION AREAS AND WORK
SPACES IS PROHIBITED.
BEFORE THE FIRST USE
After unit transportation or storage at
low temperature keep it for at least three
hours at room temperature.
•
Unpack the unit and remove any stickers
that can prevent unit operation.
•
Check the unit for damages; do not use it
in case of damages.
•
Before switching the unit on, make sure
that voltage of the mains corresponds to
unit operating voltage.
•
Clean the unit body with a damp cloth and
then wipe it dry.
• Wash all removable parts with warm water
and neutral detergent, then rinse and dry
thoroughly before assembling.
OPERATION MODE SWITCH
The marks on the switch (8) correspond to
the following operation modes:
«
0» – the meat grinder is off, the middle posi-
tion of the switch.
«
ON» – the meat grinder is on, the fixed posi-
tion of the switch.
«
R » – reverse mode, the switch position is
not fixed.
ATTENTION!
•
The meat grinder is intended to mince
boneless meat for household use only.
•
Before grinding meat, make sure that
meat is fully defrosted, all bones and
excess fat are removed. Cut meat into
small pieces (no more than 2 cm x 2 cm x
6 cm), so they can fit easily into the food
tray (2) opening.
• Place the unit on a flat dry surface.
• Make sure that ventilation openings on the
unit body are not blocked.
• Do not push the products with any foreign
objects or your fingers, use only the push-
ers (1) or (14) supplied with the unit.
IM VT-3613.indd 5 08.12.2017 14:05:53