Vitec Multimedia CellCom 10, Инструкция по эксплуатации

Страница: 54 / 90

C E L L C O M 1 0 W I R E L E S S C O M M U N I C A T I O N S Y S T E M
6 - 4
Enter/Answer-Back Button
The enter/answer-back button has two primary purposes. When you view the
menus on the beltpack’s display screen, you can select an option by pressing this
button and you can exit a menu by selecting the up-arrow icon. In this way, the
button serves as an enter key.
During normal beltpack operation it functions as the answer-back key, with
which you can activate a talk to an unassigned source when the answer-back
“talk” light illuminates to indicate an incoming call (see description in “Beltpack
Top Control Section” above).
BELTPACK REAR/BATTERY SECTION
Figure 4: View of Back of Beltpack
Power Button
The recessed power button is used to turn the CellCom 10 beltpack on and off.
Press and hold the button for about three seconds to turn the unit on. To turn
the unit off, again press and hold the button for about three seconds.
Battery Case
The removable battery case will hold four alkaline AA or four NiMH
(nickel-metal hydride) rechargeable batteries. These batteries alternate, with the
negative pole contacting the spring and the positive pole contacting the plate
inside the case.
To remove the battery case, press on the top of the belt clip to lift it off the case,
and with the thumb and middle or ring finger of the other hand squeeze the side
tabs of the case and lift it out, slightly tilting the lower (toward the bottom of the
beltpack) portion of the pack out first.
To insert the battery pack, follow the above instructions in reverse. Note that the
battery case has a clip-on lower cover; make sure to put it back in place before
putting the battery case back into the beltpack.
Caution: Do not put battery packs containing alkaline batteries into a recharger, or
recharge them in the beltpack. Serious damage or injury could result.
3
Power Bu tt on Bel t Clip
Ba tt ery Case
1
2
3
1
2