Vitec Multimedia CellCom 10, Инструкция по эксплуатации

Страница: 14 / 90

C E L L C O M 1 0 W I R E L E S S C O M M U N I C A T I O N S Y S T E M
2 - 2
If the beltpacks do not connect to the base station within 30 seconds, check
that they are registered to the base station. If they are not, refer to the
CellCom
Toolkit User’s Guide for instructions on registering the beltpacks to the base
station.
Figure 1: Connect the CellCom Base Station to the Wired Devices
5. To get the CellCom 10 into a “clean” state for the example below, from the
base station’s front-panel display, scroll to and select PORTS, then 4WIR1,
then CALLS, then NONE. (NONE is the last element in the list.) Then also
select PORTS, then PLCHA, then CALLS, then NONE. (See Figure 2.)
Figure 2: Clear the Base Station’s Memory and Enable the Party Line
POWER
PL CH-A PL CH-B PRGM IN SA OUT
SA RLY
4-WIRE / ECLIPSE PORTS
1 2 3 4
BASE
LOOP
LAN
PC PROGRAM
TRANSCEIVER
1 2
90-260V, 50/60Hz
80 Watts
2
3 4
CellCo m 10 Base Statio n Rear Pa n el
Co nn ect XLR cable to
party-li n e beltpack
Co nn ect CAT-5 cable
to 4-wire a u dio so u rce
Co nn ect CAT-5 cable to
CellCo m 10 a n te nn a
Cha nn el A
Eclipse Matrix
CellCo m 10 A n te nn a
Party-Li n e Beltpack
8 7
MAIN MENU
BELTPACKS PORTS GROUPS SYSTEM
Use the scroll/enter knob to scroll to
and select PORTS, then 4WIR1, then
CALLS, then NONE. Then select PORTS,
then PLCHA, then CALLS, then NONE.
Press the CH A enable button
to enable the party line.
Always power up external
party-line equipment,
CellCom splitters, and
CellCom active antennas
before powering the
CellCom 10 base station.