Vitec Multimedia CellCom 10, Инструкция по эксплуатации

Страница: 13 / 90

C E L L C O M 1 0 W I R E L E S S C O M M U N I C A T I O N S Y S T E M
2 - 1
QUICK START
The following exercise demonstrates how to set up a simple configuration of
wired and wireless devices in a CellCom 10 system. You should have some
familiarity with how CellCom 10 operates before attempting this exercise. If you
do not, please read through the manual first, and then do the exercise.
To complete the exercise, you will need the following equipment.The goal is to
establish communication between these devices:
• A CellCom 10 system including two wireless beltpacks, an antenna, and a base
station.
• A 4-wire audio source, such as an Eclipse matrix.
• A wired beltpack, such as a Clear-Com 501 or 601 beltpack.
Specifically, this quick-start exercise shows you how to:
• Wire the CellCom 10 base station to a party-line beltpack, a 4-wire audio
source, and a CellCom 10 antenna.
• Assign labels to two CellCom10 wireless beltpacks.
• From the CellCom 10 base station, create a group containing the wired and
wireless devices.
• Initiate calls between members of the group.
Note : For a quick overview of the CellCom 10 programming menus, refer to
Appendix 2.
CONNECTING THE BASE STATION
To connect the CellCom base station to a party-line beltpack:
1. Make sure the CellCom base station is powered off.
2. Connect an XLR cable from the “PL CH-A” connector on the rear of the
CellCom base station to a wired party-line beltpack, such as an RS-601. See
Figure 1 for an illustration.
Note : Externally powered party-line equipment, CellCom splitters, and
CellCom active antennas should always be connected and powered up before
powering the CellCom base station.
To connect the CellCom base station to a 4-wire matrix port:
1. Connect a CAT-5 cable from the CellCom base station’s leftmost 4-wire audio
port (labeled “4-Wire/Eclipse Ports”) to an external 4-wire audio source, such
as an Eclipse matrix port. See Figure 1 for an illustration.
2. Connect a CAT-5 cable from transceiver port 1 on the CellCom base station’s
rear panel to a CellCom antenna. See Figure 1 for an illustration.
3. Power up the base station.
4. Power up the beltpacks.
This exercise demonstrates
how to set up a simple
configuration.
In this exercise, you establish
communication between a
group of wired and wireless
devices.
2