vita V60 i-Line, Руководство по эксплуатации

Страница: 18 / 36

18
VITA V60 i-Line ®
20.1 Pre-drying
Press the pre-drying program area.
The display shows:
Selected program area, here:
pre-drying, is shown as active
The display field for the pre-drying time
lights up in light blue and is active. Enter
the value for the time using the keypad.
Input value: 0:00-40:00 min / sec.
Display field for the pre-drying temperature.
Enter the temperature using the keypad.
Input value: 200 °C - 800 °C.
Activates / deactivates
pre-drying
In this mode, all program areas
can be selected and edited.
Time for the upper lift position
(calculated automatically)
Time setting for the middle lift position
Time settings for the lower lift position
Lift position settings
Icons indicate the lift positions
Times for the individual pre-drying positions:
The hold times possible for the individual lift positions depend on the pre-
drying time that has already been selected. For this reason, set the pre-drying
time first before entering the time for the middle and lower lift position. The
time for the upper lift position is calculated automatically.
If the pre-drying time is extended , the change in time is allocated to the
upper lift position. The lower and middle positions are retained.
If the pre-drying time is shortened , the hold time is shortened for the
upper lift position. The lower and middle positions are retained.
If the selected pre-drying time is less than the total time of the individual lift
hold times, this is allocated at 1/3 each to the individual lift positions.
The lift positions (in %) are retained if the hold times are changed and can be
modified as required. The factory defaults are set as follows: lift position 1 at
0%, lift position 2 at 15% and lift position 3 at 30%.
Program values that have been modified are shown in red in the program
overview and can be used for a program sequence or saved permanently
using the save button in the program overview (see section 20.5).
Changes to the pre-drying temperature result in changes to the
activation temperature of the vacuum pump. Changes to the pre-
drying temperature result in changes to the hold times of the lift
positions.