vita V60 i-Line, Руководство по эксплуатации

Страница: 13 / 36

13
VITA V60 i-Line ®
16.1 Starting / switching to standby
Press the standby button. The lift is retracted into the firing chamber and the
firing chamber heated to the standby temperature as set. Once the standby
temperature has been reached and maintained for 5 minutes, the device is
ready for firing. When standby is started for the first time after the furnace is
switched on, the firing chamber remains slightly open for 5 minutes in order
to remove moisture from the firing chamber.
The standby button shows two temperature values. You can choose between
normal mode (standby temperature can be set to, e.g., 500 °C) and power-
save mode (fixed value of 200 °C). The temperature during normal mode can
be adjusted using the device settings / standby temperature. (See section
21.11.) Pressing the button again while standby is active allows you to switch
between normal and power-save mode. The active mode is shown in red.
Standby is exited when the green START or red STOP button, the program
name button, or the program number button are pressed.
standby button
Last firing program selected
Start screen
16 Switching on the device
Switch on the device using the
main switch
(on the left of the device).
The red and green LEDs next to the display light up. If the firing chamber
temperature is less than 200 °C, the lift performs a reference run.
After approx. 30 seconds, the start screen is displayed on the control unit and
the red LED goes out. A self-test is carried out during this time.
After a further 60 seconds, the last firing program used is displayed.
1st dentine firing
1st dentine firing
STOP button
START button