Vision VR48 4 Series, Руководство пользователя

Страница: 339 / 352

Maintenance 339
© 2015 Vision Engraving and Routing Systems
Working in the lubricants
After completing these procedures, the lubricants should be worked in to the motion system for several
minutes prior to using the machine. To move the motion system, use the X,Y and Z Buttons on the
pendant to move the machine through its range of motion and evenly distribute the lubricants.
What not to lubricate
Many of the bearings and assemblies in your engraving machine are sealed and/or coated using
special low-friction methods and should not be lubricated.
DO NOT attempt to lubricate the spindle or the spindle bearings on the router head or the engraving
head. This will attract particles and dust, which will build up between the shaft and sleeve and possibly
prevent movement. If you suspect lubrication problems, call your dealer/representative or the service
department at Vision.
DO NOT oil the stepper drive motors. None of the motors on the Vision VR48 require lubrication. Oiling
the stepper motors can cause permanent damage.