Vision VR48 4 Series, Руководство пользователя

Страница: 152 / 352

Vision VR48 Series 4 Router User Manual 152
© 2015 Vision Engraving and Routing Systems
7.1.3 Burnishing
In this section, we will set up to engrave with a burnishing cutter. The figure below shows a spindle with
a burnishing cutter and an optional EZ Rider burnishing adapter.
Spindle with Burnishing Cutter and EZ Rider Burnishing Adapter
Burnishing is different than standard rotary engraving mainly because the nose cone is not used to set
the depth of cut. Burnishing does not actually cut deep into metals, rather it cuts the painted surface off
of metals. To effectively burnish, it is recommended to use an optional EZ Rider burnishing adapter.
This helps to control the pressure of the cutter applied to the material. Burnishing requires less
pressure than other types of engraving and the EZ Rider attachment applies the proper amount of
pressure for burnishing.
Installing the EZ Rider is similar to using a cutter knob. First, screw the EZ Rider into the top of the
spindle hand tight. Next, insert the cutter through the EZ Rider and spindle so that the cutter sticks out
below the nose cone approximately 1/8 inch (3 mm). Tighten the set screw in the EZ Rider to hold the
cutter in place.
In order to set the engraver up for burnishing, we will need to perform a "Set Surface" function. Turn
the machine on and place the material on the table. Follow the steps below to perform the Set Surface
procedure.
a) Use the X & Y jog buttons to move the spindle over the material to be engraved.
b) Press the Set Surface button. The Pendant screen will display the message below