MOTOR REPLACEMENT
(T7400/8400/8500/8600)
Tools required:
ü
Philips screwdriver
ü
T-handle wrench (14mm)
ü
Ratchet Box Wrench (11mm)
Procedure:
1.
Remove screws from the front cover by using the screwdriver and remove it.
2.
Remove cables connecting to the motor and lower board, remove also the ground
wire by using the screwdriver.
3.
Remove the motor mount screws by using the T- handle wrench.
4.
Replace the motor.
5.
Secure the motor mount screws (not too tight at this time so that the tension
adjustment can be made).
6.
Place the drive belt on the transmission pulley, turn the flywheel clockwise by
using your left hand and place the drive belt on to grooves of the front roller
pulley.
7.
Adjust the belt-tension-adjusting screw until the tension is within 80 ~ 90lbs.
8.
Tighten the motor mount screws
(remark1
).
9.
Reconnect cables and the ground wire.
10.
Turn on the power and enter the Engineering Mode to check if the extreme speeds
are within the correct range.
11.
Try to step on the belt at low speed to check if the belt slips.
12.
Install the front cover and secure the screws.
Remark1: The centerline of motor shaft has to parallel with the centerline
of roller.
7-10 Revision: 1.0 Date: 2001-06-01
Содержание Vision Series
