INCLINE MOTOR REPLACEMENT
(T7400/8400/8500/8600)
Tools required:
ü
Philips screwdriver
ü
Wrench (14mm)
ü
Wrench ( 17mm)
Procedure:
1.
Remove screws from the front cover by
using the screwdriver to open the cover.
2.
Disconnect cables from the connectors of the
incline motor and MCB and also disconnect the
ground wire.
3.
To prevent the frame from falling down heavily while removing the incline
motor, put a support with proper height under the front of frame.
4.
Remove the bolts and the nuts from the
incline motor by using the wrenches (14, 17).
5.
Replace the incline motor with a new one.
6.
Reconnect cables and the grounding wire to
the connectors and the frame.
7.
Remove the support under the frame.
8.
Turn on the power and enter the Engineering Mode to check if the extreme inclines
are within the correct range.
9.
Install the front cover and secure the screws.
7-12 Revision: 1.0 Date: 2001-06-01
Содержание Vision Series
