30
A100K10652
IP DECT 6000 System Installation & Configuration Guide
6.6.2 Setting up the Hardware for Repeater
Programming
1. Unplug the repeater power supply and insert the splitter.
2. Connect the repeater power supply to the splitter and the mains. The
LED should start to flash.
3. Ensure that you have the appropriate power supply for the local
requirements.
4. Connect the serial cable to the splitter and COM port of your
computer. The repeater is now ready for programming via
ServiceTool.
)
The order sequence (steps 1, 2 and 3) of the setup should be followed.
6.6.3 Programming the Repeater with ServiceTool
ServiceTool is the application software installed on your computer that
you use for repeater programming and software downloading to the
repeater.
ServiceTool identifies the type of repeater, and with this software it
is possible to program the repeater to connect to the DECT Radio
Infrastructure solutions.
Before you start programming the repeater, ensure that the repeater is
connected to the computer and the mains.
In a single cell solution, the numbers assigned to the repeaters must be
between 2 and 7. The number of the base station is set to 1 by default.
In a multi-cell solution, the numbering of the base stations and repeaters
has to follow the numbering in the table below.
Table 8 Repeater Numbering in a Multi-Cell Solution
Base Station
Repeater 1
Repeater 2
Repeater 3
0
64
128
192
1
65
129
193
2
66
130
194
3
67
131
195
4
68
132
196
5
69
133
197
6
70
134
198
7
71
135
199
8
72
136
200
9
73
137
201
10
74
138
202
11
75
139
203
12
76
140
204
13
77
141
205
14
78
142
206
15
79
143
207
16
80
144
208
