vimec V64 B.C., Использование и обслуживание

Страница: 24 / 49

7602026
23
7) ASSEMBLING THE PLATFORM
a)
Remove the top plate from the platform by undoing
the relative screws.
b) Make sure that the two platform supports, fixed by a
wedge and a plastic clamp, are in the assembly position
(Fig. 27/a/b).
c) Fit the platform, keeping it vertical and turning it
through 90° as shown in (Fig. 28).
d) Fix the platform to the frame using the relative M8
flathead screws (Fig. 28/a).
e) Fix the two microswitches of the sensor base (Fig.
29/a) to the platform, passing them between the sensor
base and the platform frame (Fig. 29/b).
If necessary, back off the sensor base tripping cams
(Fig. 29/c) to allow the microswitch to pass.
Then restore the original positions so that the sensor
base trips the microswitches when it is pressed.
f) Connect the lateral guard board operating cables to
the relative bar actuators, passing them around the pin
(Fig.30/a).
If the guards are not opened or closed correctly, adjust
to the specified position using the register fork (Fig.30/
b).
g) Replace the top plate on the platform using the rela-
tive fixing screws.
h) Remove the wedge and the plastic clamp (Fig. 27/
c/d) used to keep the platform horizontal during the
adjustments from the platform supports.
i) Tighten with a driving torque of 4 daN ± 0,1the dowel,
the nut and the locknut (Fig. 29/d,e,f).
l) Check friction group is engaged.
FIG.27
FIG.28
a
FIG.29
b
c
b
a
c
d
a
e d f