vimec V64 B.C., Использование и обслуживание

Страница: 26 / 49

7602026
25
11) FINAL TESTING
Supply power to the system and perform the
following functional checks:
- Load test:
- Load the lift with 1.1 times the rated load stated on
the nameplate.
- Send the lift up and down several times, checking its
stability on the rail.
- Drive the machine to the upper level and place the
platform as to let the unloading of the bodywork and
assemble the cam on the guide (Fig. 33/a), so that the
rise limitstop micro is pressed on (Fig. 33/b).
- Drive the machine to the lower level and place the
platform as to let the unloading of the bodywork and
assemble the cam on the guide (Fig. 33/c),so that the
descent limitstop micro operates (Fig. 33/d).
- Repeat the operation to check the operating of the
limit stop and extra stroke micro, making the machine
rise and descent.
-Lock the cams with the indicated cylindrical pin Ø4x30.
- Place the third cam (mechanical extra stroke) with
the indicated cylindrical pin Ø4x30, on the guide decent
side paying attention to assemble it rotated 180° (Fig.
33/e).
- Preliminary checks
Perform the checks described in point 6.1 on page 8 of
the Use and Maintenance Manual.
- Safety gear test
Test the safety gear as described in Section 9, point
“d”.
(This test must be carried out with no load on the lift).
- Check on fixing of the rail
- Check that the rail is positioned in accordance with
the dimensions stated in the installation drawing (or
system layout) supplied with the lift.
- Check that all the fixing screws of the connections to
the mounts or any expansion plugs are stable and firmly
tightened.
FIG.33
SN CARRIAGE CONFIGURATION
FRONT VIEW
MAC
HINE
ADV
ANC
E
RISE
SIDE
DES
CEN
T
SIDE
a
e
~ 130
c
d
a