vimec V64 B.C., Использование и обслуживание

Страница: 11 / 49

11
7502026
CAUTION: In the B.R. - B.I. Version , the plat-
form can only be operated with the down side bar in the
working position.
N.B.: If the platform fold button is accidentally pressed
when someone is on the lift, a motor overload cut-out is
tripped, stopping the electromechanical actuator. Be-
fore using the lift, the cut-out must be reset by pressing
the button provided - Fig. 13/a.
7.3) Lift operated by attendant.
If the person who uses the system is not self-sufficient,
the lift may be operated by an attendant, using the same
control board - Fig. 2.
The guiding person must follow the machine subse-
quently from earth with respect to the moving direction.
7.4) Stairlift stopped at the other end of the stair-
case (optional call - send function).
1) Insert the key in the control board at the floor and
turn it to ON - Fig. 9/a.
2) Keep the call or send button (Fig. 9/c/d) pressed until
the lift has reached its destination.
3) Remove the key from the control board, close the
rubber lid (Fig. 9/a).
CAUTION: Never send/call the lift to a floor
unless the WHOLE travel route can be seen.
7.5) Manual operation in emergency
Skill level OC: Trained operator with specific skills
This emergency operating mode is used to bring the
person being transported to a floor in case of a power
black-out or a failure of the system.
CAUTION : before operating in manual mode, the
operator MUST press the emergency switch (STOP)
(Fig. 2/e) and remove the key.
After pressing the emergency switch, proceed as fol-
lows:
Moving the lift
1) Remove the central cap from the casing (Fig. 14/a).
2) Fit the handwheel provided (Fig. 14/b) into the hole,
fitting it into the square shaft (Fig. 14/c) and turn the
handwheel to move the lift.
3) With the floor is reached, remove the handwheel and
replace the cap.
4) Restore normal operation of the lift once the emer-
gency conditions cease.
Safety bars
1) B.C. (Connected bars) , undo the bar release screw
provided (on the front of the bodywork above the han-
dle facing towards the up side) (Fig. 15/a) using the
Allen key provided with the stairlift.
1) B.I. (Indipendent bars) , undo the bar release screw
provided on the front of the bodywork above the handle
(Fig. 16/a).
1) B.R. (Retractile bars) , there are two screws to be
undone (one for each safety bar - Fig.17/a).
2) Raise with the hands the safety arms (Fig. 15/b-16/
b-17/b) and hold them in position during the pick-up of
FIG.13
a
b
FIG.14
a
b
c
b
a
FIG.15
BARS
RELEASE
EMERGENCY
the conveied person.
3) Reset the normal functions of the equipment after
the emergency.