vimec V 64, Использование и обслуживание

Страница: 9 / 64

9
a
b
a
d
c
b
c
b
7511131
FLOOR CONTROLS
6.2) Electrical connection
The power supply lead is of 4x1 mm2 type (number of
wires per gauge).
The electrical system of the stairlift must be connected
to the electrical line at 230 V single-phase 50 Hz, by
means of a 16 A circuit-breaker (main circuit-breaker)
and a differential security breaker of 0.03 A, both con-
tained in a box with padlock fitting.
The electrical line at 230 V must comply with the current
national regulations.
WARNING: The box with padlock fitting
containing the master switch must be installed
close to the stairlift.
There must be no obstacles to access to this box.
NOTE: If a dedicated line with a differential switch
cannot be installed, a 16A plug with in series a 10A
fuse shall be provided.
7) USING THE STAIRLIFT CORRECTLY
WARNING: BEFORE USING THE STAIRLIFT,
READ THIS MANUAL CAREFULLY. The stairlift must
only be used in accordance with the intended uses
described in section 5.
Keep the manual on the stairlift.
7.1) Initial situation
The stairlift is parked at the top or bottom of the stai-
rcase with the platform folded up (Fig. 8/a) and the
bars in rest position (Fig. 8/b) with the master switch
turned to ON.
7.2) Using the stairlift
WARNING: Always keep access to the platform
and the master switch unrestricted.
NEVER overload the stairlift.
1) For stairlifts with manual platform (standard).
- B.R. - B.I. Version
- Bring the down side bar into the working position by
pressing the button (Fig. 9/d) on the control board at
the floor.
- Lower the platform by hand.
- If the stairlift is at the lower floor, bring the down
- side bar into the rest position to allow the wheelchair
to move onto the platform.
1) For stairlifts with motor-operated platform (op-
tional)
-
Insert the key and turn it to position (1) ON using the
control board at the floor - Fig. 9/d.
- Bring the down side bar into the working position by
pressing the button (Fig. 9/d) on the control board at the
floor. The platform will open at the same time.
- B.R. - B.I. Version
The side guard moves to the drive-on position and the
down side bar to the working position.
If the stairlift is at the lower floor, return the down side
bar to the rest position to allow the wheelchair to move
onto the platform.
- Remove the key from the control board at the floor.
2)
Salire sulla pedana,rivolti verso il senso di marcia
ed in posizione centrale (Fig.10),tale da permettere il
movimento della bandella in funzione di sensore.
Bloccare la carrozzina con i freni di cui è dotata e, se
elettrica, spegnerla.
WARNING: The wheelchair must be positio-
ned on the platform so that no part of the body or
the wheelchair projects from the platform. When the
stairlift is in motion sit still without moving or rocking.
3)
Insert the key in the control board on the stairlift (Fig.
9/a) and turn it to (1) ON.
FIG.10
FIG.8
FIG.9
RH CONTROL
BOARD ON LIFT
LH CONTROL
BOARD ON LIFT
7512131