vimec V 64, Использование и обслуживание

Страница: 23 / 64

23
c
a
b
a
b
c
a
a
b
c
5
c
h
i
7511131
EARTH
CONNECTION
WITH CONSOLE
Fix the down limit switch plate (SQ16 or SQ12) (Fig.
12/g).
- Fix the up limit switch plate (SQ16 or SQ12) and the
up over-run microswitch (SQ4) (Fig. 12/h).
- Connect the safety gear microswitch connector (SQ2)
(Fig. 12/f).
- Fix the lift body to the carriage by means of the 3 screws
- Fig. 12/d, checking that it is horizontal. (Tightening
torque M10x1 - 3.5 DaNm).
- Use a bit with diameter 10 mm to drill a hole at least 4
mm deep in the carriage plate through the M12 hole
(Fig. 18/a) on the frame. Then screw the M12x25 stud-
bolt supplied into the hole and fix it with the nut provided.
- Fit the drive chain (Fig. 18/b) with links as supplied and
adjust using the chain stretcher (Fig. 18/c), pre-mounted
on the lower of the carriage.
If a double drive chain is supplied, assemble it with
links as supplied and adjust using the chain stretcher
(Fig. 18bis/c) pre-assembled on the lower side of the
carriage. Then adjust the chain microswitch leaving 5
mm clearance between the microswitch wheel and the
bracket (Fig. 18bis/h).
FIG.18
FIG.15
FIG.17
FIG.16
FIG.18 bis
7512131