35
Placing the Ember Material
Ember material is shipped with this gas fireplace. The bag
labeled Glowing Ember (050-721) is standard glowing
ember material. To place the ember material:
•
Remove the top louver by lifting it up and away from the unit.
•
Unlatch the latches at the top and bottom of the glass door.
•
Remove the glass door from the unit (see Figure 40).
Positioning the Logs
If the gas logs have been factory installed they should not
need to be positioned. If the logs have been packaged
separately, refer to the instructions that accompany the
logs.
Save the log instructions with this manual.
If sooting occurs, the logs might need to be repositioned
slightly to avoid excessive flame impingement.
GLASS SPECIFICATIONS:
QV36
24 5/8 x 35 3/8
TEMPERED
QV32
21 1/8 x 30 3/8
TEMPERED
___________________________________________
___________________________________________
Shutter Settings
NG
LP
QV32
3/16”
FULLY OPEN
QV36
1/8”
FULLY OPEN
Village Collection fireplaces manufactured with tempered
glass may be installed in hazardous locations such as bath-
tub enclosures as defined by the CPSC. The tempered
glass has been tested and certified to the requirements of
ANSI Z97.1-1984 and CPSC 16 CFR 1202. (Safety Glazing
Certification Council SGCC # 1595 and 1597. Architec-
tural Testing, Inc. Reports 02-31919.01 and 02-31917.01.)
This statement is in compliance with CPSC 16 CFR Sec-
tion 1201.5 “Certification and labeling requirements” which
refers to 15 USC 2063 stating “…Such certificate shall ac-
company the product or shall otherwise be furnished to
any distributor or retailer to whom the product is delivered.”
Some local building codes require the use of tempered
glass with permanent marking in such locations. Glass
meeting this requirement is available from the factory.
Please contact your dealer or distributor to order.
Figure 40. Glass Assembly
LATCHES
(BOTH TOP AND
BOTTOM)
GLASS
ASSEMBLY
•
Place dime size pieces of ember material about 1/2
inch apart near port holes in burner top. Do NOT press
embers into burner ports. Cover the top of the burner
with a single layer of ember material. For best perfor-
mance do NOT place embers on the ports at the rear
of the burner (see Figure 41).
Figure 41. Placement of the Ember Material
EMBER MATERIALS
•
Save the remaining ember materials for use during fire-
place servicing. The bag of embers provided is suffi-
cient for 3 to 5 applications.
•
Reinstall and latch the glass door and top louver on the unit.
CAUTION: THE GLASS DOOR MUST BE SECURELY
LATCHED BEFORE OPERATING THE UNIT.