18
The Speaker Mode will be set to one of the following two modes. This is selected automatically based on Inbound Call Mode.
OFF/Silent Monitoring Mode:
In the “OFF” mode the speaker is disabled on inbound calls. However, the speaker
can be enabled after communication has been established by entering touch tone command “
9#
”. The speaker will
then remain on for the duration of the call.
ON (Factory Setting):
In the “ON” mode the speaker is enabled during In-bound and Out-bound calls.
23. Speaker Mode
When set to “Enabled” the Remote Access Operation Commands to Un-Latch or Latch the relay are enabled.
When set to “Disable” the Remote Access Operation Commands to Un-Latch or Latch the relay are disabled. Disabling
the Latch commands can be useful in applications where you want to eliminate the possibility of inadvertently entering
a latch command leaving a gate open/closed, etc. The relays can still be activated with the “Relay Activation Command”
for momentary closures.
Factory Setting:
Enabled
22. Relay Latch Commands
The speaker volume can be set from 0 - 9, 0 = lowest volume setting, 9 = highest volume setting. Alternatively the
speaker can be turned off for silent monitoring (see Speaker Mode section 23).
Factory Setting:
3
24. Speaker Volume
The microphone volume can be set from 1 - 9, 1 = lowest volume setting, 9 = the highest volume setting. Alternatively
the microphone can be placed in the “Auto” (Automatic Noise Cancelling) mode. With the mic in the Auto mode, when
background noise increases, the mic gain will automatically decrease. When background noise decreases the mic gain
will automatically increase. The Auto mode is useful in applications where the background noise level can change
drastically such as a gas car running vs a diesel truck.
Factory Setting:
5 seconds
26. Microphone Volume / Automatic Noise Cancelling Mode
This feature selects switching time between talk and listen modes (VOX switching time). The Talk/Listen Delay can be
programmed from 0.1 - 0.9 seconds.
Factory Setting:
0.5 seconds
29. Talk / Listen Delay (VOX)
The In-Band Audio Call Progress Detection can be set to enabled or disabled. In-Band Audio Call Progress detection
should be enabled in applications where you are making an outbound call through your VoIP phone system and are
relying on In-Band analog audio for ringback or busy detection.
Factory Setting:
Enabled.
27. In-Band Audio Call Progress
The In-Band Audio Detect level (Sensitivity) can be set from 1 - 9, 1 = minimum setting, 9 = highest setting. Increasing
or decreasing the sensitivity may be required in applications where you are making an outbound call through your VoIP
phone system and are relying on In-Band analog audio detection.
Factory Setting:
5
28. In-Band Audio Detect Sensitivity
25. Ring Volume
The Ring Volume can be set from 0 - 9. 1 = the lowest volume, 9 = the highest volume and 0 = disabled. When set to
“Disabled” the extention will ring when called but no ringing will be heard from the speaker. The call can be answered
by momentarily pressing the call button.
Factory Setting:
5
30. Phone Mode
The Phone Mode can be programmed to one of two settings: Auto Dialer or Manual Dial Phone. When set to Auto
Dialer the
K-1700-IP
will auto dial any preprogrammed phone numbers stored in the Phone Number Database when
the corresponding Speed Dial Number (example: apartment number) is entered on the unit’s keypad. When set to
Manual Dial Phone the unit’s auto dialing features are disabled and the unit functions as a standard VoIP speaker
phone. Pressing the call button will take the phone off hook allowing you to manually dial the phone number on the
keypad. Keyless entry codes can be used in either mode.
Factory Setting:
Auto Dialer