7
Select the Feature:
Momentarily touch the Green (Control) wire to the Black (-) wire 1 to
10 times to select which feature to program, see Programming Features List to the right.
The strobe should momentarily flash each time the Green (Control) wire has touched the
Black (-) wire.
Features 1-3 & 6-10:
After selecting Programming Features 1-3 or 6-10, wait 3 seconds
and the strobe should flash 2 times indicating that feature has been programmed. You can
now exit programming or move on to programming the Beacon or Strobe brightness settings.
Setting Strobe Brightness
(factory set to 6/Brightest): After selecting Programming Feature
4 (Strobe Brightness), wait 3 seconds and the strobe should begin flashing in the
preprogrammed flash pattern. Touch and hold the Green (Control) wire to the Black (-) wire.
The
SL-2
will begin flashing the strobe cycling through 6 different brightness settings from
lowest to highest. When the
SL-2
flashes at the desired brightness level immediately remove
the Green wire from the Black. The
SL-2
should flash twice indicating the selected brightness
level has been set.
Setting Beacon Brightness
(Factory set to 6/Brightest): After selecting Programming
Feature 5 (Beacon Brightness), wait 3 seconds and the beacon will light at its
preprogrammed beacon brightness setting. Touch and hold the Green (Control) wire to the
Black (-) wire. The
SL-2
will begin stepping through 6 different beacon brightness settings
from lowest to highest. When the
SL-2
lights at the desired beacon brightness level
immediately remove the Green wire from the Black. The
SL-2
should flash twice indicating
the selected brightness level has been set.
Exiting Programming:
To exit programming simply wait 20 seconds from the last
programming command and the unit will flash 3 times. This indicates the
SL-2
has exited
the programming mode and is now in the Run mode.
Note:
To eliminate waiting 20 seconds,
you can also exit programming after the last programming command by touching and holding
the Green (Control) wire to the Black (-) for 3 seconds. The strobe will flash 3 times indicating
the unit has exited the programming mode and is now in the Run mode.
B. Programming Desired Features
(after accessing the Programming Mode as shown on page 6)
Feature
Number
Description
1
Beacon/Strobe
(factory default)
2
Strobe Only
3
Beacon Only
4
Strobe Brightness 1-6
(factory default = 6,
brightest setting)
5
Beacon Brightness 1-6
(factory default = 6,
brightest setting)
6
Single Flash Strobe
(factory default)
7
Double Flash Strobe
8
Quad Flash Strobe
9
Flicker Flash Strobe
10
Reset to Factory
Default Settings
Programming Features List
Repeat
ON
ON
ON
OFF
ON
OFF
ON
ON
ON
OFF
OFF
OFF
0.10
sec
0.10
sec
0.10
sec
0.20 sec
0.10
sec
0.05
sec
0.025
sec
Typ.
0.025
sec
Typ.
8 Pulses
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
0.80 sec
OFF
0.80 sec
OFF
0.80 sec
OFF
0.80 sec
Repeat
Repeat
Repeat
Single
Flash:
Double
Flash:
Quad
Flash:
Flicker
Flash:
C. Strobe Flash Patterns
