5
Installation and Specifications
0.35 Diameter
(2 places)
Use 5/16" bolt
and flat washer
(included)
4.750
0.75
6.0
4.000
1.000
0.325
5.400
3.0
3.00
3.12
4.750
0.125
5.000
0.75
35.760
1.25
1.50
0.875 Dia.
4.500
0.250
2.87
1.37
1.50
0.125 Diameter
Condensation
Drain Hole
Knockout for
1/2 inch conduit
42.0 in.
(± 0.1)
42.0 in.
(± 0.1)
Self-clinching
nut 6-32
(8 places)
Side View
Back View
Front View
Bottom
View
“ASSISTANCE” on models
E-1600-ASTIPEWP
E-1600A-AST2IPEWP
or
“EMERGENCY” on models
E-1600-BLTIPEWP
E-1600BLT2IPEWP
“ASSISTANCE”
on models
E-1600-ASTIPEWP
E-1600AST2IPEWP
or
“EMERGENCY”
on models
E-1600-BLTIPEWP
E-1600BLT2IPEWP
A
S
S
I
S
T
A
N
C
E
A
S
S
I
S
T
A
N
C
E
Rain Guard
(included)
Adhere gasket to chassis,
centering over mounting holes
CALL
CONNECTED
PUSH FOR
VIKING
©
HELP
Phone
Panel
Adhere gasket to chassis,
centering over mounting holes
SL-2
Strobe/
Beacon
Strobe Panel
Attention
: To make sure water drain
notch between stobe and panel is
facing down, attach strobe panel with
wire exiting left side of panel.
Step 1.
Mount the tower phone approximately 42” above the floor to a flat, sturdy surface using 5/16 hardware.
Note:
Flat
washers should be used on the main mounting bolts for additional strength.
Step 2.
Locate the strobe light panel and attach red, black and green 42” wire extensions with butt connectors then pass the red,
black and green wires from the strobe panel through the gasket and the upper hole in the tower.
Step 3.
Mount the strobe panel to the tower using the four security screws provided. Attention: To make sure water drain notch
between stobe and panel is facing down, attach strobe panel with wires exiting left side of panel.
Step 4.
Locate the phone panel. Using the gel-filled butt connectors, wire the Strobe Light to the Phone panel as shown on Page 6.
Step 5.
Connect CAT 5 or greater Ethernet cable to RJ45. (See Page 8)
Step 6.
Mount the phone panel to the tower using the remaining four security screws.
