Viking Designer Topaz, Руководство пользователя

Страница: 20 / 80

1 2
20
Set Up
Lower the feed teeth
The feed teeth are lowered when you move the switch on the
front of the free arm to the right. Move the switch to the left if
you wish to raise the feed teeth. The feed teeth will raise as you
begin to sew. The feed teeth should be lowered when sewing on
buttons and for free motion sewing.
When embroidering, the feed teeth are lowered automatically as
the embroidery unit is connected. When the embroidery unit is
removed, the feed teeth are raised automatically when you start
sewing.
Changing the presser foot
Turn off the ON/OFF switch
1. Make sure the needle is in the highest position and the presser
foot lifted. Pull the presser foot towards you.
2. Line up the cross pin on the foot with the gap in the presser
foot ankle. Push back until the foot snaps into place.
Changing the needle
Turn off the ON/OFF switch
1. Use the hole in the multipurpose tool to hold the needle.
2. Loosen the screw in the needle clamp with the screwdriver.
3. Remove the needle.
4. Insert the new needle using the multipurpose tool. Push the
new needle upwards with the Á at side away from you until it
will go no further.
5. Use the screwdriver to tighten the screw.