Viking Designer Topaz, Руководство пользователя

Страница: 10 / 80

OFF
ON
1 2 3
10
Set Up
1. Set Up
Unpacking
1. Place the machine on a sturdy, Á at surface, remove the
packaging and lift off the cover.
2. Remove the packing material and the foot control.
3. The machine is delivered with an accessory bag, a power cord
and a foot control cord.
4. Wipe the machine, particularly around the needle and stitch
plate to remove any soil before sewing.
Connecting the foot control cord
Among the accessories you will À nd the foot control cord and
the power cord. Connecting the foot control cord to the foot
control is only necessary the very
À rst time you are going to use
the machine.
1. Take out the foot control cord. Turn the foot control over.
Connect the cord to the socket inside the space of the foot
control.
2. Push À rmly to make sure it is properly connected.
3. Lay the cord in the slot on the underside of the foot control.
Connect the power cord and foot
control
On the underside of the machine you will À nd information about
the power supply voltage (V) and the frequency (Hz).
Note: Before plugging in the foot control, check to ensure that it is of type
“FR5” (see underside of foot control).
1. Connect the foot control cord to the front socket on the
bottom right side of the machine (1).
2. Connect the power cord to the rear socket on the bottom
right side of the machine (2).
3. Press the ON/OFF switch to ON to turn on power and light
(3).
For the USA and Canada
This sewing machine has a polarized plug (one blade wider
than the other). To reduce the risk of electric shock, this
plug is intended to
À t in a polarized outlet only one way. If
the plug does not À t fully in the outlet, reverse the plug. If
it still does not À t, contact a quali À ed electrician to install
the proper outlet. Do not modify the plug in any way.