Viking Designer Topaz, Руководство пользователя

Страница: 17 / 80

C
A
B
C
D
17
1
Set Up
Bobbin Winding, model 30
Winding the bobbin with the
machine threaded
Make sure that the presser foot is up and the needle is in the
highest position.
Note! Do not use a plastic presser foot when bobbin winding.
1. Place an empty bobbin on the bobbin winder on the top
of the machine. The bobbin only À ts on one way, with the
logo facing up. Use only original HUSQVARNA VIKING®
bobbins.
2. Thread the machine with the main spool pin in the horizontal
position.
Note: If the thread spool is too large to be in horizontal position, wind
the bobbin as described under “Winding Specialty Threads” below.
3. Pull the thread from the needle under the presser foot and to
the right through the bobbin winding thread guide (C).
4. Guide the thread through the hole in the bobbin (D) from the
inside to the outside.
5. Push the bobbin winder lever towards the bobbin to wind.
A pop-up message appears on the GraphicDisplay. Press the
OK button to start winding. To adjust the winding speed use
the left/right arrow buttons. Hold the thread
À rmly when
starting to wind. Once the bobbin begins to wind, cut the
excess thread.
Once the bobbin is full, the bobbin winder lever will move
back and the winding will stop automatically. The pop-up
message closes. Remove the bobbin and cut the thread using
the bobbin thread cutter.
Winding Specialty Threads
We do not recommend winding speciality threads such as
“invisible” or other stretchy threads, metallic or
Á at metallic
threads through the needle.
Always wind these threads at minimum speed.
1. Place an empty bobbin on the bobbin winder on the top
of the machine. The bobbin only À ts on one way, with the
logo facing up. Use only original HUSQVARNA VIKING®
bobbins.
2. Place the large spool cap and a felt pad under the spool on the
main spool pin set in the vertical position.
3. Bring the thread over and behind the pre-tension thread
guide (A) and down around the thread tension disc (B), then
through bobbin winding thread guide (C) as illustrated.
4. See Winding the bobbin with the machine threaded, step 4-5.
Note: Depending on the type of thread, wrap the thread one or two
turns around the bobbin thread tension disc (B) to put more tension
on the thread. Embroidery weight bobbin thread should be taken two
turns around the bobbin thread tension disc.
Note: When using earlier version of HUSQVARNA
VIKING® bobbins that do not have a hole, wind several
turns of thread on the bobbin to get started.