Viking Designer Topaz, Руководство пользователя

Страница: 18 / 80

B
C
E
F
G
1 2
3 4
I
H
D
18
Set Up
Bobbin Winding while embroidering or
sewing
Model 30 has a separate motor for bobbin winding to wind
bobbins while sewing or embroidering.
1. Place an empty bobbin on the bobbin winder on the top
of the machine. The bobbin only À ts on one way, with the
logo facing up. Use only original HUSQVARNA VIKING®
bobbins.
2. Raise the auxiliary spool pin. Place the large spool cap, felt
pad and thread spool on the spool pin.
3. Bring the bobbin thread around the thread tension disc (B)
and through the thread guide (C) as illustrated.
4. Guide the thread through the hole in the bobbin (D) from the
inside to the outside.
5. Push the bobbin winder lever towards the bobbin to wind.
A pop-up message appears on the GraphicDisplay. Press the
OK button to start winding. To adjust the winding speed use
the left/right arrow buttons. Hold the thread
À rmly when
starting to wind. Once the bobbin begins to wind, cut the
excess thread.
Once the bobbin is full, the bobbin winder lever will move
back and the winding will stop automatically. The pop-up
message closes. Remove the bobbin and cut the thread using
the bobbin thread cutter.
Note: Make sure that the thread does not touch the cap of the horizontal
spool pin when winding the bobbin. If it does, place the cap and spool on
the vertical spool pin higher.
Inserting the bobbin
1. Remove the bobbin cover by sliding it towards you.
2. Place the bobbin in the bobbin case. It drops in only one way
with the logo facing up. The thread unreels from the left of
the bobbin. The bobbin will then rotate counter-clockwise
when you pull the thread.
3. Place your À nger on the bobbin to keep it from turning as you
pull the thread À rmly to the right and then to the left into the
tension spring (E) until it “clicks” into place.
4. Continue threading around (F) and to the right of the thread
cutter (G). Slide on the bobbin cover (H). Pull the thread to
the left to cut (I).
Note: When using earlier version of HUSQVARNA
VIKING® bobbins that do not have a hole, wind several
turns of thread on the bobbin to get started.