Vigilant
Inc.
Assembly Instructions for Sentinel End Table
Page
8
Step 7: Locate the adjustable shelf and four shelf pins. Insert shelf pins into the chosen position by inserting
the pins into holes in the side panels. Set the shelf on top of the shelf pins so that the pins rest in the grooves
on the bottom of the shelf. Note that the shelf position leaves space in the back of the cabinet so humidified
air can circulate evenly.
Step 8: Door Installation
The versatility of the Vigilant hardware allows you to mount your door to the cabinet with the hinges on the
left or the right. Therefore, you must first determine whether the hinges will be attached on the left or the
right side of the cabinet. NOTE: The hinges and hinge plates are shipped connected as one unit, so be sure
to notice how the plate and hinge go together as you separate the parts. Disconnect the plates from the
hinges by squeezing the hinge release. (See Figure 8b, page 10.)
•
Take the first hinge plate with the arrows pointing toward the front of the cabinet and insert the two
black pins in the plate into the pre-drilled holes on the side of the cabinet. Note: the hinge holes do
not line up with the shelf pin holes. There is a set at the top and bottom of the cabinet’s side panel.
•
Take the second hinge plate and repeat by inserting the black hinge plate pins into the holes near the
bottom of the side panel, making sure to press the plate firmly against the cabinet side. Snap the
levers closed.
•
Lay the door on a flat, scratch-free surface with the hinge holes facing up. Take the first hinge, and
with rectangular cover plate open, press the round part of the hinge firmly into the holes in the door
and snap the rectangular plate closed.
•
Repeat for the second hinge.
•
Standing the door upright, open the hinges and line them up with the hinge plates on the cabinet.
Figure 7
