Vigilant
Inc.
Assembly Instructions for Sentinel End Table
Page
11
Door Pull
Locate the paper template for location of door hardware. (It’s the last page of these instructions.) If you are
printing this document, make sure you print it full size without “scaling.” The measurements in inches are
indicated on the template.
Using the template for location, pre-drill a screw hole with a 3/16" drill bit. Be sure to place a scrap of wood
on the back side of the door while pre-drilling to prevent the wood from chipping on the opposite side.
Attach the door pull with the screw provided.
Step 9: Install modesty blocks onto the back panel of the cabinet
Make sure the door and cabinet are “square” and level. Turn cabinet on face and place two modesty blocks in
pre-drilled locations on back of cabinet assembly. Using (6) modesty block screws, attach each modesty block
to cabinet sides with two screws and to the back with remaining screw.
Optional: If your cabinet has a glass top, place the glass into the grooves on the tabletop.
Figure 9
