Vigilant
Inc.
Assembly Instructions for Sentinel End Table
Page
6
Step 3: Locate the back panel and slide it into the dadoes on the top and bottom panels, down into the dado
on the side panel. Note that the power cord hole in the back panel should be toward the bottom of the
cabinet.
Step 4: Locate the left side panel and place on a flat, protected surface. Insert a connector stud into each of
the connector stud holes. Place the left side panel onto the top, bottom and back panels by aligning connector
studs with cam fittings and aligning dadoes. Fit the connector studs into each cam fitting on the top and
bottom panels. Tighten the cam fittings around the connector studs by turning clockwise 180 degrees. Do
not over-tighten.
Back panel
Left side panel
Figure 3
Figure 4
