Vigilant
Inc.
Assembly Instructions for Sentinel End Table
Page
5
Step 1: Locate the right side panel and lay it on a flat, scratch-free surface (such as a blanket) with the dadoes
(or grooves) facing up. Insert 3 connector studs into the provided holes in each dado at the top and bottom of
the panel. Insert 1 connector stud at the bottom corner for the trim.
Step 2: Locate the top panel (not the table top). Lining up the dadoes with the side panel, place each cam
fitting over the connector studs on the side panel. Make sure that the cam fittings are facing to the outside of
the humidor. Tighten the cam fitting around the connector studs by turning clockwise 180 degrees. DO
NOT OVER-TIGHTEN.
Locate the bottom panel and attach to the other end of the side panel, following Step 2, above.
Top panel
Bottom panel
Right side panel
Top panel
A
SSEMBLY
I
NSTRUCTIONS
Figure 1
Figure 2
