Vigilant
Inc.
Assembly Instructions for Sentinel End Table
Page
10
Adjusting the Door Position
The position of the door can be adjusted by turning the screws on the hinge plate. (See image 2.) Line the
door unit up with the sides and bottom of the cabinet, adjusting the hinge screws as necessary.
Moving the door up, down, left or right: Turn the adjustment screws on the hinge plate to bring
the door up or down. Both screws must be adjusted. The screws on the front of the hinge arm move
the door to the left or right. Note that both hinges may need adjustment to get the door exactly
square to the cabinet.
Moving the door in or out: Turn the adjustment screw on the back of the hinge arm to move the
door closer to the cabinet or farther away. This may be required in order to get the door to land
properly on the cabinet front.
Troubleshooting Door Position
•
If door is binding on the hinge side: Turn the In/Out adjustment screws counter clockwise to
move the hinge side of the door out slightly.
•
If door is too far away from the cabinet on the hinge side: Turn the In/Out screw clockwise
to move the door closer to the cabinet.
•
If door is not closing tightly at the lock side: Turn the In/Out adjustment screws counter
clockwise slightly until the door closes tightly.
•
If door is not closing tightly at the bottom: Adjust the bottom hinge only. Turn the In/Out
screw clockwise until the top and bottom of the door close evenly.
•
If door is not closing tightly at the top: Adjust the top hinge only. Turn the In/Out screw
clockwise until the door closes tightly at top and bottom
Lock: If the lock does not engage in the slot on the cabinet side, use pliers to gently bend the lock arm inward
toward the cabinet until it slides into the groove.
Figure 8b
