Viessmann Vitocal 300 AWO-M-AC 301.A, Инструкция по установке и обслуживанию

Страница: 93 / 152

93
Plug Sensors/connections Type
(PTC)
F0 Outside temperature sensor; connect on site Ni500
F4
(X5.6/X5.7) Buffer temperature sensor, top; connect on site Pt500
F6
(X6.1/X6.2) Cylinder temperature sensor, top; connect on site Pt500
F7
(X6.1/X6.3) Cylinder temperature sensor, bottom; connect on site Pt500
F8
(X5.8/X5.9) Secondary circuit flow temperature sensor
Type AWCI-M-AC 301.A : connected at the factory
Type AWO-M-AC 301.A : connect on site; install in the
secondary circuit flow inside the building (cable with plug
2.0 m long; extend on site if required)
Pt500
F12 Flow temperature sensor, heating circuit with mixer (M2/
HC2); connect on site Ni500
F13 System flow temperature sensor (with sensor well, down-
stream of heating water buffer cylinder); connect on site Pt500
F14 Flow temperature sensor, cooling circuit (direct heating
circuit A1/HC1 or separate cooling circuit); connect on
site Ni500
F16 Room temperature sensor for separate cooling circuit
(requirement) or for direct heating/cooling circuit (recom-
mendation); connect on site Ni500
F20
(X6.8/X6.9) Boiler water temperature sensor, external heat source;
connect on site Pt500
aVG KM BUS
On-site component connection (wires interchangeable);
for several appliances, use the KM BUS distributor
(accessory).
■ Extension kit for one heating circuit with mixer M3/HC3
■ Vitotrol 200A remote control (assign the heating cir-
cuits at the remote control)
■ External extension H1
■ Vitocom 100 communication interface
■ Vitosolic 100/200 solar control units
Set the required parameters during commissioning; see
from page 110.
–
X5/X6 Terminals for connecting lead (LV) to the heat pump con-
trol panel (connect on site, see page 75) –
Installation sequence
Electrical connections in the heat pump control…
(cont.)
5692 875 GB
Installation