Chapter 2: Installing VidyoPanorama
31
The NETBIOS name.
The workgroup name.
9.
If needed, click the blue triangle next to the word
Display
to view the display timeout settings.
10.
In the
ScreenSaver Timeout
field, enter the number of seconds to wait before displaying the screen-
saver.
The default is 900 seconds.
11.
In the
PowerSaving Timeout
field, enter the number of seconds to wait before going into power
saving mode.
IMPORTANT
: The default is 0 (zero) seconds; do
not
change this default.
12.
Click
Save
.
13.
Click
Apply
.
If you make changes to the settings on the Configuration tab, but then decide that you do not want
to keep these settings, click the
Restore Defaults
button to restore the settings to their factory
defaults.
14.
Repeat the previous steps for each Decoder Node.
Troubleshooting and Obtaining Information About the Decoder Nodes
Besides enabling you to assign the cluster and node names, the interface to each Decoder Node enables
you to view information about the Decoder Nodes and to troubleshoot them. For example, you can obtain
logging information, view statistics, and associate and disassociate the Decoder Nodes.
To troubleshoot and obtain information about the Decoder Nodes:
1.
Open a browser on the computer that is connected to the Controller Node.
2.
Enter the IP address of one of the Decoder Nodes in this format:
[IP address of node]:8080/vidyopanorama
(case sensitive)
You will then access the interface for that particular node.
