Vido WD030210254, Инструкция по эксплуатации

Страница: 19 / 28

1800W MITER SAW ENG
10) Before turning on the saw, perform a dry run of the cutting operation to check that there are no
problems.
11) Hold the operating handle firmly and squeeze the switch trigger. Allow the blade to reach maximum
speed.
12) Press the release latch and slowly lower the blade into and through the workpiece.
13) Release the switch trigger and allow the saw blade to stop rotating before raising the blade out of
the workpiece. Wait until the blade stops before removing the workpiece.
23. Compound mitre cut
A compound mitre cut involves using a mitre angle and a bevel angle at the same time (See Fig 44). It
is used in making picture frames, to cut mouldings, making boxes with sloping sides and for roof
framing. Always make a test cut on a piece of scrap wood before cutting into the good material. Use the
slide action when cutting wide workpieces.
1) Pull on the release knob and lift the saw arm to its full height.
2) Loosen the mitre lock.
3) Rotate the mitre table until the pointer aligns with the desired angle on the mitre scale.
4) Retighten the mitre lock.
Warning: Be sure to tighten the mitre lock before making a cut. Failure to do so could result in
the table moving during the cut, causing serious personal injury.
5) Loosen the bevel lock and pull out the 0º bevel adjuster and move the saw arm to the left or right to
the desired bevel angle (between 0º and 45º). Tighten the bevel lock.
6) Place the workpiece flat on the table with one edge securely against the fence. If the board is warped,
place the convex side against the fence. If the concave side is placed against the fence, the board
could break and jam the blade.
7) When cutting long pieces of timber, support the opposite end of the timber with the side bars, a roller
stand or a work surface that is level with the saw table.
8) Use the clamp assembly to secure the workpiece wherever possible.
9) It is possible to remove the clamp assembly by loosening the clamp assembly lock and moving it to
the other side of the table. Make sure the clamp assembly lock is tight before using the clamp.
10) Before turning on the saw, perform a dry run of the cutting operation to check that there are no
problems.
11) Hold the operating handle firmly and squeeze the switch trigger. Allow the blade to reach maximum
speed and slowly lower the blade into and through the workpiece.
12) Release the switch trigger and allow the saw blade to stop rotating before raising the blade out of
the workpiece. Wait until the blade stops before removing the workpiece.
24. Adjusting the laser line
The laser is factory set to the centre of the blade width. To adjust the position of the laser, proceed as
follows:
1) Remove the laser cover by pulling it towards you.
2) Switch on the laser light with the on/off switch.
3) Using a screwdriver (not supplied), adjust the position of the laser line by turning the laser pitch
control (See Fig 45).
4) Adjust until the laser hits the centre of the blade.
19