Vido WD030210254, Инструкция по эксплуатации

Страница: 16 / 28

1800W MITER SAW ENG
3) Loosen the mitre lock (See Fig 19).
4) Rotate the table until the pointer is positioned at 0º.
5) Tighten the mitre lock.
6) Loosen the bevel lock and set the saw arm at 0º bevel (the blade at 90º to the mitre table). Tighten
the bevel lock (See Fig 20).
7) Place a set square against the table and the flat part of the blade (See Fig 21).
Note: Make sure that the square contacts the flat part of the saw blade, not the teeth.
8) Rotate the blade by hand and check the blade-to-table alignment at several points.
9) The edge of the set square and the saw blade should be parallel.
10) If the saw blade angles away from the set square, adjust as follows.
11) Use a wrench or adjustable wrench to loosen the lock nut securing the 0° bevel adjustment screw
(See Fig 22). Also, loosen the bevel lock.
12) Adjust the 0° bevel adjustment screw with the hex key to bring the saw blade into alignment
the square(See Fig 23).
13) Loosen the screws holding the pointer of the bevel scale and adjust the position of the pointer so
that it accurately indicates zero on the scale (See Fig 24). Retighten the screw.
14) Retighten the bevel lock and the lock nut securing the 0° bevel adjustment screw.
Note. The above procedure can also be used to check the angle of the saw blade to the table at the 45º
bevel angle (See Fig 25 & 26).
18. Setting the fence square with the table
1) Make sure that the electrical plug is removed from the power point.
2) Push the saw arm down to its lowest position and engage the release knob to hold the saw arm in
the transport position.
3) Loosen the mitre lock.
4) Rotate the table until the pointer is positioned at 0º.
5) Tighten the mitre lock.
6) Using the hex key , loosen the four screws securing the fence to the base (See Fig 27).
7) Place a square against the fence and alongside the blade (See Fig 28).
8) Adjust the fence until it is square with the blade.
9) Tighten the screws securing the fence.
10) Loosen the screw holding the pointer of the mitre scale and adjust it so that it accurately indicates
the zero position on the mitre scale (See Fig 29).
11) Retighten the screw securing the mitre scale pointer.
12) Replace the top section of the fence and secure the hex screw using the hex key.
19. Changing a blade
Warning: Never try to use a blade larger than the stated capacity of the saw. It might come into
contact with the blade guards. Never use a blade that is too thick to allow the outer blade washer to
engage with the flats on the spindle. It will prevent the blade screw from properly securing the blade on
the spindle. Do not use the saw to cut metal or masonry. Ensure that any spacers and spindle rings that
may be required suit the spindle and the blade fitted.
1) Make sure that the electrical plug is removed from the power point.
16
with