Vido WD030210254, Инструкция по эксплуатации

Страница: 18 / 28

1800W MITER SAW ENG
6) When cutting long pieces of timber, support the opposite end of the timber with the side support bars,
a roller stand or a work surface that is level with the saw table.
7) Use the clamp assembly to secure the workpiece wherever possible.
8) It is possible to remove the clamp assembly by loosening the clamp assembly lock and moving it to
the other side of the table. Make sure the clamp assembly lock is tight before using the clamp (See Fig
41).
9) Before turning on the saw, perform a dry run of the cutting operation to check that there are no
problems.
10) Hold the operating handle firmly and squeeze the switch trigger. Allow the blade to reach maximum
speed and slowly lower the blade into and through the workpiece.
11) Release the switch trigger and allow the saw blade to stop rotating before raising the blade out of
the workpiece. Wait until the blade stops before removing the workpiece.
21. Cross-cutting (with slide action)
When cutting wide workpieces, first unscrew the slide lock.
1) Pull on the release knob, raise the saw arm to its highest position and slide it towards you (See Fig
42).
2) Hold the handle firmly and squeeze the switch trigger. Allow the blade to reach maximum speed.
3) Slowly lower the blade into the workpiece and slide it away from you at the same time until the
workpiece is cut.
4) Release the switch trigger and allow the saw blade to stop rotating before raising the blade out of the
workpiece. Wait until the blade stops before removing the workpiece.
22. Bevel cut
A bevel cut is made by cutting across the grain of the workpiece with the blade angled to the fence and
mitre table. The mitre table is set at the zero degree position and the blade set at an angle between 0º
and 45º (See Fig 43).
Use the slide action when cutting wide workpieces.
1) Pull on the release knob and lift the saw arm to its full height.
2) Loosen the mitre lock.
3) Rotate the mitre table until the pointer aligns with zero on the mitre scale.
4) Retighten the mitre lock.
Warning: Be sure to tighten the mitre lock before making a cut. Failure to do so could result in
the table moving during the cut, causing serious personal injury.
5) Loosen the bevel lock and pull out the 0º bevel adjuster. Move the saw arm to the desired bevel
angle (between 0º and 45º). Tighten the bevel lock.
6) Place the workpiece flat on the table with one edge securely against the fence. If the board is warped,
place the convex side against the fence. If the concave side is placed against the fence, the board
could break and jam the blade.
7) When cutting long pieces of timber, support the opposite end of the timber with the side bars, a roller
stand or a work surface that is level with the saw table.
8) Use the clamp assembly to secure the workpiece wherever possible.
9) It is possible to remove the clamp assembly by loosening the clamp assembly lock and moving it to
the other side of the table. Make sure the clamp assembly lock is tight before using the clamp.
18