8. Check points before operation
Before power is applied, please check the cables carefully.
The camera ID of the controller must be identical to that of the target camera. The camera
ID can be checked by reading the DIP switch of the camera, or the boot window on power-
up.
If your controller supports multi-protocols, the protocol must be changed to match that of
the camera.
If you changed the camera protocol by changing the DIP switch, the change will take effect
only after you reboot the camera.
Since the operation method can be different for each controller available, refer to the
manual for your controller if camera cannot be controlled properly. The operation of this
manual is based on the standard Pelco
®
Controller.
8.1. Preset and Pattern Function Pre-Check
Check how to operate preset and pattern function with controller or DVR in advance to
operate camera function fully when using controller or DVR.
Refer to the following table when using standard Pelco® protocol controller.
< Go Preset >
Input [Preset Number] and press [Preset] button shortly.
< Set Preset >
Input [Preset Number] and press [Preset] button for more than 2
seconds.
< Run Pattern >
Input [Pattern Number] and press [Pattern] button shortly.
< Set Pattern >
Input [Pattern Number] and press [Pattern] button for more than 2
seconds.
If controller or DVR has no pattern button or function, use shortcut keys with preset
numbers. For more information, refer to Section 8.3
in this manual.
8.2. Starting OSD Menu
Function Using the OSD menu, Preset, Pattern, Swing, Group and Alarm Input function can
be configured for each application.
Enter Menu <Go Preset> [95]
8.3. Reserved
Preset
Description
Some Preset numbers are reserved to special functions.
Function
<Go Preset> [95] : Enters into OSD menu
<Go Preset> [131~134] Runs Pattern Function 1 ~ 4
<Go Preset> [141~148] Runs Swing Function 1 ~ 8
<Go Preset> [151~158] Runs Group Function 1 ~ 8
Doc # INS 20Z704T-PZ10
Issue Date: 08/13/2009
Revision: B
Page 17 of 40