NVR User Manual
13
2 Installation and Cable Connection
Note the following during the installation:
1.
Take out all materials required for the installation.
2.
Connect cables ﴾video signal input cables, audio signal input cables, and network cables﴿ as
required.
3.
Connect the rear panel, front panel, and power supply in sequence.
4.
Take out the regulated power adapter or power cable and connect the power supply.
2.1 Hardware Installation
Check After Unpacking
l
After you receive the product, check the appearance to see whether it is damaged during the
transportation.
l
Open the packing box and check the accessories according to the packing list.
l
Remove the protective film from the product.
Front Panel and Rear Panel
l
Read the descriptions of buttons on the front panel and interfaces on the rear panel in the
instruction.
l
Check the model on the protective film of the front panel against the order contract.
l
Keep the label on the rear panel intact. It is required for after‐sales services. Do not tear down or
discard the label. Otherwise, no warranty service will be provided. When you call after‐sales
personnel of the company, provide the serial number of the product.
Internal Check
Check for damage and scratches. Check whether data cables, power cables, and fan power supplies are
connected to the main board on the front panel properly.
Precautions ﴾Contact us if you have any doubt﴿
1.
After unpacking, ensure that the materials are consistent with the packing list.
2.
Check the voltage, avoiding device damage caused by improper voltage.
3.
Check the installation environment. Do not use the device in damp or high‐temperature environment.
Ensure proper ventilation and keep the air vents unblocked. Lay the device horizontally. Do not install
the device in environment with sharp vibration.
2.2 Hard Disk Installation
Check whether hard disks are installed when you install the device for the first time. The NVR supports
