02.2020
INSTRUCTION MANUAL
for installation and operation of pellet stove
VITTORIA В*
7
6.
Components.
Ignition
:
Performs ignition of the pellets.
Fume extractor
:
Provides the flue gases from the combustion chamber to the flue pipes and combustion air intake by vacuum.
Gear motor
:
Drives auger screw by means of which the pellets are conveyed from the pellet fuel hopper to the combustion chamber.
Circulation pump:
Provides forced circulation of the fluid in the heating system.
Closed expansion vessel
:
Compensate for differences in the volume of liquid in the integral boiler of the pellet stove when heated. Technically competent
person should assess the need for adding a second expansion vessel to the existing, depending on the total amount of liquid in
the heating system.
Air vents (manual and automatic):
They are placed on the top part of pellet stove body and they allow removal of air entered when filling the heating system with
liquid (Fig.3).
Do not forget to connect the heating system to the sewer.
7.
Operating mode.
Pellet stove works with wood pellets. These are cylindrical granules, made of pressed wood whose combustion is controlled by
an electronic control system. The heat from the combustion process is given to the liquid into the heating system.
The pellet fuel hopper, position (A) of (Fig.2), is located at the rear of the pellet stove. The hopper filling is through a hatch
located on the rear part of the top plate of the pellet stove. The pellets are transported from the hopper (A) to the combustion
chamber (D) by means of a screw auger (B) driven by a gear motor (C).
The initial ignition of the pellets is carried out by hot air which is sucked in around the ignition (E) in the combustion chamber (D)
through the fume extractor (F). Fume extractor (F) provides combustion air by sucking in from air inlet Ø 50 mm position(A) in
(Fig.1) by the room or by outside atmosphere. Upon submission of air from the room must have provided an influx of outside air.
The flue gases are sucked from the combustion chamber through the fume extractor (F) and are conducted to flue socket Ø 80
mm position (C) in (Fig.1).
Fig.2.
Fig.2.1.
Fig.3.
C
G
A
F
D
E
J
