02.2020
INSTRUCTION MANUAL
for installation and operation of pellet stove
VITTORIA В*
19
-
Vacuum the combustion chamber and all contact edges;
-
Clean the glass when it is cold. If necessary, use appropriate detergent.
Never suck vacuuming hot coals, because this may damage it!
12.2. Weekly cleaning.
- Empty pellet fuel hopper and clean with a vacuum cleaner if the pellet stove was not used for an extended period.
-
- Clean ignition (Fig.9).
12.3. Cleaning ash from the flue channels.
Vigorously shake the cleaning elements by the handle (Fig.6) when the pellet stove is not working and it is cold. Open the left
and right manholes (Fig.10 and Fig.11) and clean with a vacuum clean the accumulating deposits.
Fig.10.
Fig.11.
The amount of soot depends on the quality of fuel used. If this cleaning procedure is not performed, pellet stove may jam. Upon
completion of the cleaning, make sure that all manholes are properly closed.
12.4. Seasonal maintenance (performed by the installer).
You should contact the installer to perform seasonal maintenance.
Disconnect the power supply of the pellet stove before performing any activity
- Clean pellet stove internally and externally;
- Carefully clean the pipes of the integral boiler;
- Carefully clean and remove dirt and ashes from the combustion chamber and related divisions;
- Clean propulsion parts and electric motors. Make sure there are no gaps;
- Clean the flue channels and chamber of fume extractor;
- Clean and check the circulation pump;
- Check sensors;
- Clean, check and remove all debris from the ignition system;
- Clean and check the electronic control system;
- Check all electrical cables;
- Clean the pellet fuel hopper and check auger to loosen the screw and the gear motor;
- Check and replace the door seal;
-
Make a functional test, insert a small amount of wood pellets in the hopper enough to fill auger. Light a pellet stove
for 10 minutes and shutdown.
It is recommended that the chimney have to be cleaned every three months in intensive use of the pellet stove.
After performing the cleaning procedure, improper attachment of the combustion chamber can seriously harm the
efficiency of pellet stove. Make sure the combustion chamber is properly assembled before starting the pellet stove
If maintenance procedures are not performed regularly, the guarantee shall be considered invalid!
12.5. Maintenance and control.
The chimney, to which is connected to the pellet stove must be cleaned once a year. Check that there is a regulatory standard
for this in your country. If you do not make periodic inspection and cleaning of chimney, the probability of fire is increased many
times. In such incident do the following:
- Do not extinguish with water;
- Empty the pellet fuel hopper of wood pellets;
- Contact the person who installed the pellet stove, before starting again.
13. Possible defects and their causes.
When a problem occurs, pellet stove automatically stops working and will be triggered by exclusion. The display shows the
reason why pellet stove has stopped working. Error messages are described below.
Do not unplug the pellet stove from the main electrical supply during process shutdown!
