Victor ULTRA-CUT 200, Руководство по эксплуатации, Страница: 42 / 168

INSTALLATION 3-16 Manual No. 0-5133
ULTRA-CUT 200
3.11 Set Switches on the Command - Control Module
Compare the command - control module to the illustration. Follow instructions in this section for a module
without an external connection cover.
Remove the power supply right side. Set switches on the CCM (Command-Control Module) per the illustrations.
Switch settings and connection details are provided in the Appendix.
CAUTION
Printed circuit boards in the Command - Control Module are static - sensitive. Discharge any built-up static
charges in your body or surroundings before touching the printed circuit boards.
SW1 SW3 SW4
SW5 SW8
3 4
1 2 3
4
1 2
1 2
1 2 1 2 1 2
SW-1-1: Auto Pilot Restart. 1 = ON = Auto Pilot Function enabled.
1 = OFF = Auto Pilot Function disabled (Factory default setting).
SW-1-2: Pilot Delay 2 = OFF, 3 = OFF, 4 = OFF: 0 Seconds (Factory default setting).
SW-1-3: Pilot Delay 2 = ON, 3 = OFF, 4 = OFF: 0.1 Seconds
SW-1-4: Pilot Delay 2 = OFF, 3 = ON, 4 = OFF: 0.2 Seconds
2 = ON, 3 = ON, 4 = OFF: 0.4 Seconds
2 = OFF, 3 = OFF, 4 = ON: 0.8 Seconds
2 = ON, 3 = OFF, 4 = ON: 1.0 Seconds
2 = OFF, 3 = ON, 4 = ON: 1.5 Seconds
2 = ON, 3 = ON, 4 = ON: 2.0 Seconds
SW-4: Postflow Time 1 = OFF, 2 = OFF: 10 Seconds (Factory default setting).
1 = ON, 2 = OFF: 20 Seconds
1 = OFF, 2 = ON: 5 Seconds
1 = ON, 2 = ON: 0 Seconds
SW-5-1: Tip Saver Reserved for Factory use.
SW-5-2: Off Plate Reserved for Factory use.
SW 8-1: Pilot Time OFF = Short (85 ms.) (Factory default setting).
ON = Long (3 s.)
O
N
O
N
Active only when
SW-1-1 is set to O N.
Art # A-09166
Future Use
SW-3: Gas Preflow Time 1 = Off, 2 = OFF: 2 seconds
1 = ON, 2 = OFF: 4 seconds
1 = OFF, 2 = ON: 6 seconds
1 = ON, 2 = ON: 8 seconds
SW 8-2: Remote Current OFF = Disabled (Factory default setting).
ON = (Remote Analog Current Control)
*SW 8-3: Auto Transfer Retry OFF = Enabled Up to 3 tries (Factory default setting).
ON = Disabled
SW 8-4: Remote Marking OFF = Disabled (Factory default setting).
ON = Remote Marking SW Enabled at TB3-1&2
* SW 8-3 is reserved for
Factory use prior to
Firmware V3.5