Victa RTS1226, Инструкция по эксплуатации

Страница: 21 / 36

21
OPERATING INSTRUCTIONS
Since the throttle lever is secured, the cutting tool starts to operate
when the engine is started.
Release the throttle lock by simply pressing the
throttle lever (the engine then returns to running in idle mode).
If the engine does not start up even after several attempts, read the
section on Troubleshooting
Always pull the starter cord out in a straight line.
IF THIS IS NOT FOLLOWED, STARTER CORD WILL BE FRAYED
AND CORD WILL BREAK!
This is not covered by the Product Warranty.
Starting the engine when warm
If the machine has not been switched off for more than 15-20 minutes
• Set the machine down on a hard, level surface.
• Move the 'STOP' SWITCH to 'ON'.
• Secure the throttle lever (in the same way as described in Starting the engine when
cold).
• Hold the machine firmly and pull out the starter until you feel it start to resist. Then tug
sharply on the starter. The machine should start after 1-2 tugs. If the machine still fails
to start after 6 pulls, repeat steps 1-7 for starting the engine when cold.
Operation
Not
for
Reproduction